GBA Logo horizontal- lakesideca.info Facebook- lakesideca.info LinkedIn- lakesideca.info Email- lakesideca.info Pinterest- lakesideca.info Twitter- lakesideca.info Instagram- lakesideca.info YouTube Icon- lakesideca.info Navigation Search Icon- lakesideca.info Main Search Icon- lakesideca.info Video Play Icon- lakesideca.info Audio Play Icon- lakesideca.info Headphones Icon- lakesideca.info Plus Icon- lakesideca.info Minus Icon- lakesideca.info Check Icon- lakesideca.info Print Icon- lakesideca.info Picture icon- lakesideca.info Single Arrow Icon- lakesideca.info Double Arrow Icon- lakesideca.info Hamburger Icon- lakesideca.info TV Icon- lakesideca.info Close Icon- lakesideca.info Sorted- lakesideca.info Hamburger/Search Icon- lakesideca.info
Video

Flashing the Jambs of Pre-Cased Windows and Doors

Air-Sealing Inspection of a Window Durable Window Installation A Home Energy Audit Most Recent Videos Job Site Visits Green Home Tours Get the Most from GBA

Video Transcript: There’s another way to do a jamb flashing on a cased door, and that’s using a pre-made flashing tape designed specifically for door and cased window installations. This one is already prepared for both the face flashing, which goes on the wall, as well as the back flashing, which would go to the jamb as well as the back side of the casing itself. The part that goes on the back side of the casing and the jamb is already pre-scribed, which makes it real easy to pull off the release liner and expose the sticky part—and we can do that right now. We’ll just extend this down over the bottom of the jamb of the door by about 3 or 4 inches. Inside corners must be tight I’ll pull off that first strip of release liner, and then I’ll fold that adhesive part back onto its face so that it doesn’t stick when I put it on. This is a butyl-based adhesive, so it’s not quite as aggressive as an asphalt based, so that makes it a lot easier to work with. In the event that it sticks on to the jamb of the door—you don’t want it there—you just pull it back a little bit and reposition it, like I gotta do here. It’s really important to get it tight and crisp into the inside corner. We don’t want any bridging between the back of the casing and the back of the jamb, or we could end up with a problem with the door being held out from the wall a little bit. This middle strip of release liner will…

0 Comments

Log in or become a member to post a comment.

Related

Community

Recent Questions and Replies

  • |
  • |
  • |
  • |
https://ford.niko.ua

http://designprof.com.ua

www.best-cooler.reviews/best-insulated-cooler-high-end-rotomolded/