0 Helpful?

Energy savings from better wall system / insulation?

I'm looking for charts indicating rough energy savings / heat load changes for various wall system decisions. E.G., going from a standard 2x6 wall (5.5" = R16.2 @ 16"oc) to a double 2x4 wall (7" = R20.1 @ 16"oc + less thermal bridging).

I've seen charts that show this but have been unable to find them. This is for what is effectively a simple two story woodshop with few windows and none on the north side.

Thanks,

Asked by W Ramsay
Posted Jun 12, 2018 9:30 AM ET
Edited Jun 12, 2018 3:19 PM ET

Tags:

1.

W. Ramsay,
To answer your question, you either need energy modeling software, or you need to sharpen your pencil.

The answer depends on your climate zone (heating degree days and cooling degree days), your heating appliance type, your fuel type, and your fuel costs, among many other factors.

Your most important equation is this one:
Q = HDD*A*U*24

Explanation:
Q = annual heat loss in BTU through a building component (for example, walls)

HDD = heating degree days for your location (look it up online)

A = area of the component under consideration (for example, walls)

U = the U-factor of the component -- which can be calculated thus: U=1/R

You multiply by 24 to account for the conversion from a hourly metric (U) to a day-based metric (HDD).

Once you know the annual heat loss, you have to figure out what it costs you to get those BTU. That depends on your appliance type and fuel cost.

If you are considering Option A (perhaps R-20, which is U-0.05) and Option B (perhaps R-30, which is U-0.033), you would make this calculation twice. Once these calculations are complete, you'll know how many BTU you need for each option (and therefore how many BTU per year are saved by upgrading your wall insulation).

Needless to say, this approach doesn't consider cooling costs or cooling savings. For that, software is best.

Answered by Martin Holladay
Posted Jun 12, 2018 11:23 AM ET
Edited Jun 12, 2018 11:28 AM ET.

2.

Thanks Martin. This is in Minnesota. I'm just trying to get a rough idea. E.G., likely 2% less energy used so not worth doing more than standard or 34% less and likely worth it.

HVAC folks think almost no difference so not worth it. Which is possible. I did a very quick run w/ an older version of PHPP and got 34% which sounds way off but that could be operator error.

Answered by W Ramsay
Posted Jun 12, 2018 11:58 AM ET

Other Questions in Energy efficiency and durability

Mortar bridging and droppings

In General questions | Asked by Stephen Cook | Jun 16, 18

Building Code Reqs for Stacked Window Headers, Bracing, Stucco over Foam

In Building Code Questions | Asked by Zane Bridgers | Jun 17, 18

Roof / wall connection showing vent above structural sheathing

In Green building techniques | Asked by Ethan T | Jun 15, 18

Room over garage

In General questions | Asked by Jay Raja | Jun 16, 18

Do I need an HRV/ERV for a house built in 1947?

In Mechanicals | Asked by Will82 | Jun 14, 18
Register for a free account and join the conversation


Get a free account and join the conversation!
Become a GBA PRO!